Congestion Relief

Ramp Meters

What is the latest on ramp meter use on Washington's state highways?

Drivers will notice newly activated ramp meters in the Tukwila, Bellevue, Parkland and Lakewood areas. The newly installed ramp meters are located at these locations: 

 

  • Interurban Avenue South (State Route 181) on-ramp to southbound I-405
  • Coal Creek Parkway on-ramp to southbound I-405
  • State Route 7 (Pacific Avenue) on-ramps to westbound SR 512
  • Steele Street on-ramp to westbound SR 512 

Why is WSDOT adding new ramp meters? 
These time-tested tools that help reduce highway congestion have long been used in King, Snohomish and Pierce counties. 

What are ramp meters? 
Ramp meters are stop-and-go traffic signals that control the frequency with which vehicles enter the flow of traffic on the freeway. 

Why does WSDOT install ramp meters?
WSDOT uses ramp meters to reduce collisions and decrease travel times for commuters. Most ramp meters allow only one vehicle through each green light, creating a 4 to 15 second delay between cars entering the highway. This delay helps reduce disruptions to freeway traffic and reduces accidents that occur when vehicles merge onto the highway. 

How do I use them? 
Drive your vehicle up to the white line, or stop bar, to trigger the ramp meter. If the light is red, stop at the white line. When the light turns green, merge onto the freeway. If there is a high occupancy vehicle (HOV) bypass lane, buses, carpools and vanpools do not have to stop at the ramp meter signal. They have the right of way over vehicles merging into traffic from the metered lane.

Where can I find ramp meters? 
The majority of ramp meters are located on our busiest highways - I-5, SR 520, I-90, I-405 and SR 167. Typically, ramps are metered from 6 a.m. to 9 a.m. and from 3 p.m. to 7 p.m. These times may vary depending on the level of traffic congestion.

Why are they effective? 
Without ramp meters, multiple cars try to merge simultaneously. Drivers on the freeway slow down to allow the cars enter and these slower speeds quickly cause backups. If cars enter the highway in controlled intervals, they are less likely to cause a disruption to the traffic on the freeway. A short wait on the ramp allows drivers to increase their average freeway speed and shorten overall freeway travel times. Ramp meters also reduce the number of collisions that often occur when multiple vehicles merge onto the highway at the same time.

How do ramp meters work? 
Ramp meters are part of a large computer-operated system that is managed in WSDOT's Traffic Management Centers (TMCs). Traffic detection devices, including magnetic loops and radar, detect traffic  speeds and volumes on highway lanes and ramps, and provide those data to the TMCs. The traffic data are continually fed to the ramp meters, which automatically alter their cycles to maximize traffic flow on both the ramps and the freeways.

Ramp Meter Facts

  • Ramp meters reduce collisions system-wide by at least 30%.
  • On I-405 in Renton, ramp meters provided a travel times savings of 3 to 16 minutes.
  • Ramp meters are a proven and cost-effective method of relieving traffic congestion.