Design: Policy Publications & Resources | Future Revisions of the Design Manual
Listed below are the Design Manual revisions anticipated to be in upcoming revision cycle. You can tell a revision has been approved when a date appears in the Approved column below. Approvals are done by WSDOT Management and the FHWA.
- Active links allow you to download chapters or revisions that have been approved but have not yet been published in printed form.
- These active links are advance copies of the Design Manual, however. It is advised that you consult with your Assistant State Design Engineer (ASDE) before using them.
- The revisions listed are approved but available to view only if there is an active link.
- The Design Manual errata is developed and updated after each manual revision.
A revision has been approved when an date appears in the Approved column.
|
Approved |
Fall 2008 Chapter Revisions
Under development and subject to change |
Contact Person |
|
|
100 "Manual Description" |
Jim Klinck |
|
|
150 "Project Development Sequence" |
Jim Klinck |
|
325, "Design Matrix Procedures" |
Chris Schroedel |
|
|
330 "Design Documentation, Approval, and Process Review" |
Chris Schroedel |
|
640, "Geometric Cross Slope" |
Ted Focke |
|
710, "Traffic Barriers" |
Rod Erickson |
|
|
850, Traffic Control Signals" (Minor revisions) |
Rod Erickson |
|
900, "At Grade Intersection Control" (NEW) |
Ted Focke/Traffic |
|
|
910, "Intersections At Grade" |
Ted Focke/Traffic |
|
|
915, "Roundabouts" |
Ted Focke/Traffic |
|
940, "Interchanges" |
Ted Focke/Traffic |
|
1020, "Bicycle Facilities" |
Chris Schroedel |
|
|
1025, "Pedestrian Design Considerations" |
Jm Klinck |
|
|
1130, "Retaining Walls and Steep Reinforced Slopes" |
Jim Klinck |
|
1420, "Access Control" |
Schrodel/De St Croix |
|
1425, "Interchange Justification Report" |
Schrodel/De St Croix |
|
1430, "Limited Access" |
Schrodel/De St Croix |
|
|
|
|
|
|
|
Approved |
Anticipated Spring 2009
Under development and subject to change |
Contact Person |
|
|
In the process of dividing the Design Manual into two volumns; Geometics and Procedures. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
top